Dirty water after winter is evident in most pools. Solution? Cleaning your pool beforehand is a good start. Many people will wait and be disappointed after they try all kinds of bleaches, and it doesn’t work. Some stains are just too adamant for a wire brush. They require some special attention to clear the stain and make the walkway clear so that you can have a good time.
What Causes Pool Stains?
Pool stains differ because of various reasons from using chemical cleaning agents that are not appropriate or are substandard, thereby causing harm to your pool. According to the experts at thepoolstainremovers.com.au, hiring professionals to undertake pool cleaning for you is the best option for an assured cleaning. Below are some causes of common pool stains:
- Organic stains happen because of algae, mildew, and other natural phenomena like leaves, etc. They can be removed using a wire brush and shock treatment, but some algae stains will call for further treatment from professionals to fully clean the stains.
- Metal stains in pools are from naturally occurring substances like dirt and water. These metals like copper and manganese concentrate on the pool surface, causing a dark appearance on the pool surface. The cleaning of the stains by the ionization process is most effective.
- Hydration stains result from water accumulating beneath the pool’s surface. It usually happens when your pool contractor plasters the pool while the form is still wet or when there is moisture or humidity in the air. When the groundwater is high, hydration may occur.
Steps On How To Clean Your Pool
When cleaning your pool, it is essential to follow the correct steps to achieve the right and healthy pool water you can get. Bacteria in water can cause bodily harm and an overall nasty experience in what is supposed to be an amazing swim experience.
Uncover the swimming pool
Remove the pool cover that you put over the pool when winter comes. Now, carefully remove all debris on it and thoroughly wash it with pressurized water. Dry it and pour some powder to make sure it doesn’t stick when stored- you will need it when summer retires.
Inspecting the pool
Check your pool for structural damages like cracks, as well as stains that may be needing attention. Note these areas of concern so that you can take the appropriate measure. The inspection helps with the diagnosis of the problem size and available solutions.
Check the water levels in the pool
The correct water levels must present for an excellent pool to commensurate. If the levels are low, top your pool up using the water in the swimming pool already, composition-wise.
Remove winter fixtures
During winter, plugs and compensators are in place to protect the pool systems from frost and blockages. Remove these fixtures and replace them with summer fixtures.
Health check on water pumps and filters
Water pumps can get blocked, and filters blocked or break. You will need to check their health before starting them. A professional technician should see into all the structural damage on the pump. If they seem okay, start them and allow them to run before beginning your cleaning process.
Clean the pool
After inspecting the pool, you may notice some stains, dirt, and debris on the pool. Use a vacuum to clean the pool floors thoroughly. It may stir the decanted dirt and cause the water to be discolored, not to worry, as chemical cleaning will attain the original rich blue water appearance. Filter the water after 24 hours from vacuuming.
Wash the stains with scrubbers and detergents or bleach. If they don’t shade off, you will need to get a pool cleaning agent from a nearby pool cleaning dealer. However, you can save yourself the stress and contact pool cleaners who will aid you in restoring your pool.
Chemical balancing of the pool water
The pool water has to have the recommended composition of chemicals and metals. Balancing the water PH level between 7.2-7.4; use soda ash to raise and sodium bisulfate to lower it. Calcium is another chemical composition that should be in adjustment (150-250 ppm) and chlorine at 1-3 ppm. Keep adding chlorine over the following few days after the initial addition to maintain the levels of balance. Lastly, the alkalinity of the pool must be between 80-120 for optimum comfort and balancing.
Now that you’ve learned how to clean a pool after the winter and revive the tiles to their original luster, you’re ready to put on your suit and hop in!